Importance of Sewer Pipe Cleaning for New and Old Homes

There is no doubt that regularly performing the necessary sewer pipe cleaning measures will save you a big amount of money in the long run. No matter how new or how old your house may be, you need to make sure that your sewer system is clean in order to provide your family with clean water. Believe it or not, the sewer is usually connected to the rest of the water system. Any slight damage to the sewer may lead the used water to infiltrate your home’s freshwater supply. To save your family from the dangers of any water-borne diseases, it is not enough to merely maintain the pipes that lead water into your home. You also have to extend particular attention to preserving and maintaining your sewage system, as well.

Newer homes rarely have problems with their sewer lines because of the material that is used to manufacture the pipes used in their pipe lines. PVC pipes, which have become the most commonly used implement, pose very little chances of breaking and corroding. Newly-built homes may go years without even showing the slightest signs of any problem. Unfortunately, older iron or clay pipes do not hold the same promise. In addition to corroding and breaking, tree roots, grease, and other elements may cause problems with these pipes, too.

Needless to say, it is important to perform even the most basic sewer pipe cleaning measures, no matter which material your pipes are made of. However, because of the higher damage risk that clay and iron poses, older homes would benefit more from regular maintenance that newer homes would.

Generally, the sewage system of older houses has lower quality that that of newer ones. In addition to the difference of the material used, there is also a difference between the plumbing and construction techniques used for the two. Since newer homes generally use newer construction and plumbing concepts, it is safe to assume that their sewer lines could better withstand present day circumstances.

Homeowners who live in relatively older houses should definitely think about having the pipes of their sewer lines replaced with newer ones. While this will definitely cost a big amount of money, it will definitely pose less hassle and problems in the long run. With a new sewer system, there will be a lesser need to maintain and to clean the sewer pipes. You will be able to save up on the time and energy required to maintain your pipe lines.

Sewer pipe cleaning is a big necessity, whether you have an old or a new sewage system installed. However, older homes would regularly need more maintenance than newer ones. Have a professional sewer cleaner inspect your sewer system at least once a year to avoid any unpleasant surprises. When it comes to managing your home’s sewer pipe system, prevention is definitely better (not to mention, cheaper) than cure. Making sure that your sewer is running in tip-top shape will keep you from experiencing any major inconveniences in the future.

Tips to Take Care of Your Septic System

Maintaining a septic system is not a difficult job. As a matter of fact, it won’t cost you a lot to maintain one. If you need some tips to care for your septic system, we suggest that you follow the tips given below.

Perform Inspections Frequently

Ideally, you should inspect your installation once every three years. For this, we suggest that you hire a good professional. Typically, household tanks are pumped once every 3 to 5 years. Moreover, alternative systems that have float switches, mechanical parts or pumps should be checked more frequently. Below are factors that can help you determine how often you should check the system.

· The size of your septic tank

· Amount of solid in the wastewater

· Wastewater generated

· The size of your household

Septic providers

A septic service provider inspects your system for leakage, sludge layers and other things. In this process, what you need to do is maintain the records related to the work done on the system.

Actually, this type of tanks features a T-shaped outlet in order to prevent sludge from going out of the tank and getting into the drain area. So, if the bottom of that layer is not more than 6 inches of the outlet bottom, you need to pump your tank once again.

Use Water Sparingly

In a typical home, the average water consumption by each individual in a house is around 70 gallons per day. And if there is just one leaky toilet, the water wastage per day is 200 gallons.

And the problem is that the water ends up in the septic system. So, if you use water sparingly, you will have lesser problems associated with your septic system.

Dispose of Waste

You can either flush it down the toilet or grind it in a special garbage disposal. In short, everything will get stuck in your septic system. The fact of the matter is that what goes into your drain will have an effect on your septic system.

Toilets Are Not Dust Bins

Don’t take your septic system as a trash can. You need to keep a simple rule of thumb in mind: don’t let anything go down into your toilet. You should never flush the following things into your toilet:

· Oil or cooking grease

· Photographic solution

· Flushable wipes

· Condoms

· Diapers

· Coffee grounds

· Cigarette butts

· Paper towels

Maintain The Drain field

Your drain field is part of your septic system. It removes a large amount of contaminants that get out of your septic tank. Given below are a few things that you can do for its upkeep.

· You should never drive or park in the drain field

· If you plant trees, plant them away from the drain field.

· Keep your sump pumps, roof drains and other drainage systems a bit away from the drain field place.

So, if you have been looking for a guide for taking care of your septic system, we suggest that you use the tips given in this article. Hope this helps.


The 4 Most Common Septic System Problems

Septic systems are designed to process human waste and decompose it anaerobically over time. Most of the time they function perfectly, but much like any system with some amount of complexity, they are prone to some problems. Here we discuss the common septic systems problems.

Functioning Septic Systems

Septic systems break human and organic waste down into their constituent parts. The bacterial decomposition results in the formation of solids, liquids and gases. The solid part of it settles to the bottom of the tank, where it remains until it is removed by a septic tank pumper (which should be every 1 to 3 years). The gases and liquids are regularly released from the tank vents and pipes.

Almost every household has used their septic system as a dumping ground for non-organic waste. From plastic objects to tampons, people flush a wide variety of objects down the toilet, which the septic process was never designed to handle. These objects, if they do not block the pipes, make it to the septic tank and just sit there taking up space. These objects are non-biodegradable the bacteria cannot decompose them and they can only be removed by pumping the tank out.

Four of the most common problems with septic tanks are as follows:

  1. Excess water being sent to the septic tank. Excess water is never good for a septic tank because it makes the solids overflow through the vents and pipes, which then blocks them. The blockage can completely stop the system from working and cause a backup into your house.
  2. Sending paint thinners and solvents into the septic tank. These are toxic substances which are not good for the soil of the system, where they will finally find home because they are non-biodegradable too.
  3. Using too many household detergents. These detergents contain phosphates, which are helpful in algae growth. Algae can block pipes and then make the septic tank overflow.
  4. Flushing non-biodegradable products down the toilet (mentioned earlier). Non-biodegradable substances need to be regularly pumped out of the tank just because bacteria cannot decompose them.

How to solve common septic system problems:

  • Use a lesser amount of water than you do normally to solve the problem the excess water problem. There are various solutions to easily reduce water consumption. You can find some examples at your local hardware store.
  • Do not dispose of non-biodegradable waste into the septic system. At all. Ever.
  • Do not use the common detergents; instead use liquid soaps and gel soaps which do not contain phosphates.
  • Do not dispose of toxic substances like paint thinners and solvents into the septic system.
  • Finally, have your septic system pumped every few years. One to three years is the duration advised by the experts as an acceptable amount of time between pumpings.